Reverse sensing system, 4x4 switch, Rear video, Off-road indicator (SVT Raptor), Front video (SVT Raptor), Camera splice module (SVT Raptor) Automatic dimming mlrror/Compass, Trailer tow power telescope mirrors Cargo lampīrake-shift interlock, Keypad illumination, Powertrain control module wake-up, Passive anti-theft systemĭelay/accessory - moonroof, power windows, locks. Interior lighting, Puddle lamps, lighting. Heated mirror/backlight relay, Rain sensor, Reverse cameraĬircuit Breaker: Power windows, Moon roof, Power sliding backlightĭelayed accessory relay (Feeds fuse 41 and circuit breaker 47) Non-integrated compass module, Heated-only seat moduleĮlectronic locking differential indicatorĪutomatic dimming mirror, Door lock switch illumination, Radio accessory delay Instrument panel cluster, Key out inhibit solenoid, Radio info display (CID), Radio buttons, Key-in chime Interior demand lamps, Mid box power feed Power mirror switch, Memory seat module microprocessor power, Steering column switch Keypad illumination, Brake Shift Interlock (BSI), SJB microprocessor power Gently pull on the cover to make sure it is seated properly. To reinstall the fuse box cover, place the top part of the cover on the fuse panel, then push the bottom part of the cover until you hear it click shut. To remove the fuse box cover, press in the tabs on both sides of the cover, then pull the cover off. To reinstall it, line up the tabs with the grooves on the panel, then push it shut. Pull the panel toward you and swing it out away from the side to remove the trim panel. The fuse panel is located under the right-hand side of the instrument panel. If a fuse blows again contact a qualified service center.Use always an intact fuse of the same color. Never replace a broken fuse with anything other than a new fuse.Using a fuse with a higher amperage rating can cause severe wire damage and could start a fire. Always replace a fuse with one that has the specified amperage rating.Always disconnect the battery before servicing high current fuses.Before replacing fuses check that the key has been removed from the ignition and that all the services are switched off and/or disengaged.
0 kommentar(er)
